This type of scaffold is used as an alternative to traditional 'Tube & Fittings'. Although quicker to erect, System scaffolds require twice the amount of tie positions as tubular scaffolds. Current UK guidelines stipulate a 4m x 4m tie pattern for tubular (Tube & Fittings) scaffolding, but System scaffolding must be tied on all frames (every leg) due to the fact that its components (ledgers) are not continuous.

System or concept scaffold uses a latch mechanism as an alternative to free bearing joints. The interlocking components of system scaffold form standardised bays. However these can be adapted to form various structures such as saddles, cantilevers and protection fans, however it can be altered to form more complex structures with the introduction of traditional 'Tube and Fitting'

System scaffold tends to be more expensive to procure then traditional scaffold (attributed to the fixtures and fittings) however is far less labour intensive and therefore quicker to erect by correctly trained scaffolders.

If in doubt contact your System scaffolding supplier who has a legal obligation to supply a tie configuration and 'erection guide' with their materials.